Approximatrix Forums — Can't find DLL entry point...

Re: Can't find DLL entry point...

null@example.com (jeff) — Fri, 11 Aug 2017 17:49:04 +0000

The !DEC$ attributes should work properly with Simply Fortran. However, you'll need some additional work to get the DLL to be callable by 32-bit Excel. The situation with 32-bit DLLs is somewhat complicated, but we've written an article about it:

https://simplyfortran.com/blog/4/
https://simplyfortran.com/blog/5/

After reading the articles, let us know if you run into more problems.

Re: Can't find DLL entry point...

null@example.com (match) — Fri, 11 Aug 2017 10:58:39 +0000

Hello again,

By the way, I am using below statement to export the subroutine into DLL.

!DEC$ ATTRIBUTES DLLEXPORT :: TEST

However, doing some googling, I saw that above '!DEC$' is no good for SilverFrost Fortran. Is this a case for Simply Fortran too? If so, which statement should I use??

Can't find DLL entry point...

null@example.com (match) — Fri, 11 Aug 2017 10:13:38 +0000

Hi,

I build the .DLL file by going into 'Project Options'. I included target name with an extension, .DLL. Used shared library with 32 bit. All the rest of the options are set to default. I can successfully generate the .DLL file. However, when I call this file in Excel, I get an error message that it cannot find DLL entry point. Does anyone know why??