Approximatrix Forums — Ascii control characters

Re: Ascii control characters

null@example.com (baf1) — Fri, 14 Sep 2018 03:51:30 +0000

Not sure what you expect to happen when you display a control characters on screen? The windows console may not react the same as a typical ANSI terminal did in the "old days". However, both control M and control L give me the expected behavior.

Try the following program

program testcc
implicit none
integer::i
do i=1,18
write(*,"(i2,2x,a)")i,char(i)
end do
end program testcc

Re: Ascii control characters

null@example.com (imre_varga) — Thu, 13 Sep 2018 01:55:55 +0000

Hi Baf1, thanks for the suggestion but it did not work. I tried 7 different ascii codes, the only one that worked was LF ... not too exciting because a / in the format stmnt will do the same thing.

Imre

Re: Ascii control characters

null@example.com (baf1) — Wed, 12 Sep 2018 03:32:39 +0000

try

write(*,"(2a)")char(13),char(10)

Re: Ascii control characters

null@example.com (imre_varga) — Tue, 11 Sep 2018 19:00:17 +0000

Hummm ... ok ... I tried it a couple of times but I could not get it too work ... I will try again. The following did not work ???

integer cr,lf
data cr/o"015" lf/"012"/

....

write (*,5) cr,cr,lf,lf
5 format (4a1)

Thanks, Imre

Re: Ascii control characters

null@example.com (jeff) — Tue, 11 Sep 2018 12:36:27 +0000

Simple ASCII control characters should still work on Windows terminals, although BELL probably won't (most systems block that by default).

Ascii control characters

null@example.com (imre_varga) — Tue, 11 Sep 2018 06:17:48 +0000

Can the ascii control characters like FF LF CR BELL etc work on a windows system or will it only work on the old tty monitors ?

Is there anything similar for Windows systems ?

Imre